UT_TIME_SPLIT — TIME → days, hours, minutes, seconds

Shows a duration (run time, time left, time since) on an HMI as numbers or as text.

Pins

	Pin	Type	Default	What to wire
in	`In`	TIME	T#0s	Any duration
out	`Days`, `Hours`, `Minutes`, `Seconds`, `Millis`	UDINT		Parts: hours 0–23, minutes and seconds 0–59, millis 0–999; the rest is in days
out	`TotalHours`	REAL		The whole duration in hours
out	`Text`	STRING(20)		e.g. `'1d 02:03:04'` for HMIs
out	`Short`	STRING(16)		The two largest units, as UT_TIME_TEXT writes a time: `'1 h 20 m'`, `'42 m 10 s'`, `'35 s'`

Text is HH:MM:SS under a day, and Nd HH:MM:SS from one day up, zero padded:
'00:00:09', '01:30:00', '1d 02:03:04', '365d 10:20:30'.
Short is UT_TIME_TEXT's form: the two largest units, the
smaller one rounded up (T#34500ms gives '35 s'), '0 s' for 0.
A negative time is split by its size: the parts are those of the positive time,
TotalHours is negative and Text and Short start with - ('-01:01:01',
'-1 m 30 s').
Anything below a millisecond is dropped.
Works over the whole TIME range, up to 106751d 23:47:16.
For the reverse (numbers from an HMI → TIME) use UT_TIME_BUILD.